I haven't seen a TR7 in a long time. It's nice to see they are still on the road. I use to own a white one back when they were still being produced and I was in high school :) Really dating myself here. None the less, I have always liked this car except the adjusting of the valves with the shims under the cam :) I could never get it right.
Out numbered but holding its ground :) Don't know about you but those Corvettes are so much nicer than the newer ones. Especially the C8 which INMHO has deviated too much from anything resembling a true and past Corvette.
Good bye F. Decided to sell the F-Type. Rarely drove it thinking someone was going to damage it. In the end, it may be hard to believe. But, the TR6 was much more enjoyable to drive.
So I noticed there is a small oil leak on my garage floor now that the car has been sitting for a while. After a while of inspecting and following sources, I came across the following.
The head rests on the block and where you see the 2 arrows is a little bit of a ledge from the block. There is some oil pooled on top of the ledge. Looking around I see oil on the two plugs above circled in red.
I will have a better look tomorrow but I am thinking there should be no leaks from the plugs since they are plugs for water. Possibly coming from the valve cover seeping down that way? I need further investigating. However, just to be double sure, those two plugs are for water. Correct ???
I just ordered stainless steel bumpers from Harrington's. Hope they fit nicely.
So I noticed there is a small oil leak on my garage floor now that the car has been sitting for a while. After a while of inspecting and following sources, I came across the following.
The head rests on the block and where you see the 2 arrows is a little bit of a ledge from the block. There is some oil pooled on top of the ledge. Looking around I see oil on the two plugs above circled in red.
I will have a better look tomorrow but I am thinking there should be no leaks from the plugs since they are plugs for water. Possibly coming from the valve cover seeping down that way? I need further investigating. However, just to be double sure, those two plugs are for water. Correct ???